in this work, the characteristics of flow and heat transfer of a fluid containing nano particles of aluminum oxide with the water volume fraction (0.1-0.2-0.3)(v/v) percent of the reports. the overall heat transfer coefficient, heat transfer and the average heat transfer fluid containing nano water - aluminum oxide in a horizontal double pipe counter flow heat exchanger under turbulent flow con...

designing and optimization of the intake manifold is one of the important steps in the development of the internal combustion engines. in this paper, the flow inside the intake manifold of an internal combustion engine is investigated by numerical modeling. the convective flux models are adopted to simulate the unsteady compressible flow behavior. to solve the governing equations, for calculati...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

numerical and experimental analyses are performed on multilouvered fin banks in low and medium reynolds regimes to investigate the effects of dimples and perforations on flow structure and heat transfer capacity. in different reynolds numbers the flow efficiency has been calculated numerically and experimentally by flow visualization method and the results showed that dimples and perforations c...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...

sometimes the need for non-circular ducts arises in many heat transfer applications because of lower pressure drop of non-circular cross section such as square duct compared to circular tube, particularly in compact heat. but square cross section has poor heat transfer performance and it is expected that using a nanofluid as a new heat transfer media may improve the heat transfer performance of...

a numerical model is developed to simulate the transport phenomena in the flow channel between parallel plates with porous and non-porous (or impermeable) walls. the continuity and momentum equations were solved first, assuming the wall reynolds number in the range of with the suction or injection of air at a speed equal to the uniform inlet velocity. the results show that at constant inlet and...

In this work, the characteristics of flow and heat transfer of a fluid containing nano particles of aluminum oxide with the water volume fraction (0.1-0.2-0.3)(V/V) percent of the reports. The overall heat transfer coefficient, heat transfer and the average heat transfer fluid containing nano water - aluminum oxide in a horizontal double pipe counter flow heat exchanger under turbulent flow con...

an analytical study was performed to study effects of thermo-diffusion and chemical reactions on a three-dimensional mhd mixed convective flow of dissipative fluid along an infinite vertical porous plate with transverse sinusoidal suction velocity. the parabolic partial differential equations governing the fluid flow, heat transfer, and mass transfer were solved using perturbation technique and...